5 Pin 10mm LED Strip to Wire Connector rgbw Unwired Clips Solderless Adapter Terminal Extension Connection for Multicolor LED Strip Lights 12V 24V (Pack of 10)

Pay with

About 5 Pin 10mm LED Strip To Wire Connector Rgbw Unwired

These 5-pin strip to wire connectors are solution for 10mm 5050 RGBW LED strip lights connection and extension needs, DIY extention for whatever the cable length you want to connect. NOTE: 1. Make sure your LED light strip is 10mm width RGBW strip lights with 5 Soldering Pads. Not work for 8mm or 12mm width led light strips. Installation tips: Strip End: 1. Cut the strip straight perfectly, then fully open the clip. 2. Insert the light strip, align the 5 Soldering Pads of the light-emitting surface of the light with the 5-pins on the connector. Then press down the transparent cover. (Note: No need to peel off the silicone on the surface of led light strip when you want to connect WATERPROOF LED strip.) Wire End: 1.Cut the desired wire length you need and separated the 5 wires around connection part. 2. Insert wires into the connector guide slot, make sure that positive and negative on the strip light surface are corresponding to the wires. 3.Close the transparent cap with a pliers and  press down hard for several times. Ensure the metal joint pierces through the wire insulation as there are so many non-standard wires on the market! 4. reminder: no stripping of the wires.  Just be sure polarity nodes are matched up "+" to  "+" and "-" to "-". If you have any problem about installation, pls feel free to contact us. Package:  10pcs Strip to Wire Connectors (BL-TZ10XB-5)