All Categories
Specifications: Model : Automatic tool setting Color : Black + Silver Material: Grinding 4S+ superhard alloy Output mode: Normally open Normally open specification technical parameters: Output mode: A: NO (normally open) Pre-stroke: about 0.5mm Stroke: 5mm Repeatability: 0.001mm (condition: operating speed 50-200mm/min) Contact life: 3 million times Protection structure: IP67 Contact force: 1.5N (installation status: vertical) Contact material: super hard alloy Housing material: grinding 4S Contact rating: DC24V 20mA (MAX) (recommended value 10mA) resistance load Cable: 5m oil resistant *6 core ,5.5 tensile strength 30N minimum bending radius R7 Protection tube: 2.5m minimum bending radius R25 LED light: normally open Alarm signal when the stroke is exceeded Output mode: B: NC (normally closed) (2.5mm from the measurement signal) Contact rating: DC24V 100mA (resistance load)Installation instructions: 1. the props and the tool setting device must be perpendicular to the contact surface, and vertically contact the contact surface, please install as much as possible on the workbench where the iron filing area is small. 2. please be sure to use the voltage within the rated power supply range, please control the DC10-30V, the current is below 20mA, the ambient temperature range is -25° C-70° C. 3. Please control the cutter tool diameter below 20mm and the cutter speed to be below 50-200mm/min. The tool center should fall to the center of the tool face 4. When using the blowing function, the air tube has a diameter of 6 mm and an inner diameter of 45 mm. Take care to remove the iron filings and cutting oil attached to the contact surface.