T6 Low Pressure LPG Propane Gas Fireplace Fire Pit Flame Failure Safety Control Valve Kit with Thermocouple and Knob Switch（3/8" Flare Inlet & Outlet）, Suitable for Gas Grill, Heater, Fire Pit

Pay with

About T6 Low Pressure LPG Propane Gas Fireplace Fire Pit

The gas fire pit valve control assembly kit is suitable for most low pressure system without pilot burner for outdoor fire pit or fireplaces. The valve is a flame failure valve and have to work with thermocouple together. Specifications Total Length: 600mm Head Thread Size: M8*1 Max BTU rating: 50000 Working pressure: 65mbar Voltage:＞20mV Thermocouple temperature: -200 ~ 650 Degree Celsius Time For Opening Valve: Less Than 10s Operation Instructions 1).Fix the valve on a plate or board of your grill or fire pit by the head screw and flange. 2).Connect your inlet and outlet hose on inlet and outlet side. (faston it tightly enough in case of gas leakage) 3).Faston the thermocouple nut M*8 on the valve end tightly 4).Connect thermocouple and end thread well 5).Open gas by correct size knob and push your valve around 5-10s till the thermocouple head is heated enough. 6).Release your hand and it work properly If when you release hand, gas valve shut off again, Please check a).If your thermocouple is always be heated on flame b).If the thermocouple end is well connect with valve c).If the inlet and outlet side well connect with hose you have Possible problems occurs during your use Valve after turn can not stick during using Reason:  a. The thermocouple head is not heated in right place, please adjust thermocouple tip position;  b. The connection between thermocouple end and valve is not connected tight enough or too tight, please adjust the screw again. Solution: Need to push valve first then turn the spindle and hold for few seconds, it cannot stick immediately may need 5-15 Seconds. Package Included 1 Pc x Gas Control Valve with Thermocouple and Knob Switch