Tigertronics SLMOD8RI Plug & Play Jumper Module for Tigertronics SignaLink USB SLUSB8R or SLCAB8R Radio Cable

Pay with

About Tigertronics SLMOD8RI Plug & Play Jumper Module For

SLMOD8RI - This jumper module is compatible with virtually all ICOM radios that use an 8-pin round type Mic jack. This includes but is not limited to the radios listed below. Be sure to see the "PWR / SPKR Jumper Settings" note below!ICOMIC-1201/1271/1275IC-22U/25/27/28IC-228/229/251AEIC-255/260/271/290IC-2400/2500IC-37A/38A/375IC-3200/3210/3220IC-45/47/48IC-471/475/490IC-505/551/560/575IC-707/718/720/725/726IC-728/729/730/735IC-736/737/738/740/745IC-746/746PROIC-756/756PROIC-756PROII/PROIIIIC-7400/7700/7800IC-751/761/765/775/781IC-820H/901 /910PWR / SPKR Jumper Settings - To maintain compatibility with as many radios as possible, this jumper module has two small jumpers that can be set to enable Power and Speaker Audio.PWR - This jumper is *NOT* used with the SignaLink USB, but can be installed to power the older SignaLink SL-1 or SL-1+ model from your radio if there is sufficient power available on Pin #2 of the Mic connector (check your radio manual).SPKR - This jumper should only be installed if your radio has Speaker Audio on Pin #8 of the Mic jack (check your radio manual). If Speaker Audio isn't available, then you'll need to connect an audio cable between the radio and the SignaLink as described in the SignaLink Installation Manual.