AUTOOL SDT 206 12V Fuel Smoke Leak Detector Tester Locator, Diagnostic Tool EVAP System Pipes with Adjustable Flow for Automotive Car Motorcycle Boat Truck

Pay with

About AUTOOL SDT 206 12V Fuel Smoke Leak Detector Tester

How to use : 1.After assembling the leak detector accessories, fill in about 100ML of smoke oil for the first time, the scale should not exceed the MAX indicator, the filling can work continuously for 15 minutes or so; 2. Open the engine cover and remove the air filter. For some models of cars, you need to remove the air flow sensor. 3. Place the air inlet adapter on the engine intake hose port and plug the pipe tightly, make sure it is closed inside without air. 4. Connect the power cable to the car battery. The red battery clip is connect the battery positive pole and the black clip connects the battery negative pole. 5. Turn on the power switch, the indicator light POWER lights up, indicating that the smoke generator is powered normally. Press the AIR MODE air pump to start working. Only after this mode is started, you may start SMOKE MODE; 6. After the AIR MODE air pump starts working, pay attention to the pressure gauge scale. If the scale exceeds 15 PSI, the flowmeter will sink and stay still at the bottom, indicating that there is no leak detected. If the pressure rises slowly, the flowmeter monitors that there is always air inflow, then it is necessary to check whether the access system is installed properly. If there is no mistake after checking, it is detected that there is leakage in the detected system, then press the SMOKE MODE button. 7. Press the SMOKE MODE button and the smoke starts running. In this mode, if the machine that has insufficient smoke oil, or the working time is too long, the system will get overheat and the ALARM light will light up until the temperature drops to the normal range, and the machine will resume operation; 8. For different models of cars, the engine interior will be full of smoke in about 1 minute, and the system will be checked for leak points; 9. After the inspection is completed, remove the power cable and collect the