MG Chemicals 8327GF25 - Liquid Thermal Gap Filler, Silicone, 46mL Dual Pneumatic Cartridge,

Pay with

About MG Chemicals 8327GF25 - Liquid Thermal Gap

8327GF25 LIQUID THERMAL GAP FILLER, SILICONE is a two-component, flame retardant, thermally conductive silicone gap filler. It is a smooth, non-sagging paste that easily conforms to the complex shapes of any interface design. The cured product creates a thermal path that efficiently dissipates heat from electronic devices. It retains its softness after cure which maximizes stress relief during thermal cycling. 8327GF25 can be used as a liquid alternative for prefabricated solid thermal pads. If higher thermal conductivity is desired, use 8327GF41. For Use With: a) Pneumatic Dispensing Equipment b) MG Cat. #8DG50-1-1 Dispensing Gun and Cat. #8MT-50 Mixing Tips for dispensing Gun Application Instructions: Read the product’s SDS before using it (downloadable at www. mg chemicals). Cartridge To insert the cartridge in the gun (MG 8DG-50-1-1), see the Dispensing Accessories Application Guide. 1. Twist and remove the cap from the cartridge. Do not discard cap. 2. Dispense a small amount to ensure even flow of both parts. 3. (Optional) Attach a static mixer. a. Dispense and discard 5 to 10 mL of the product to ensure a homogeneous mixture. b. After use, dispose of static mixer. 4. Without a static mixer, dispense material on a mixing surface or container, and thoroughly mix parts A and B together. 5. To stop the flow, pull back on the plunger. 6. Clean nozzle to prevent contamination and material buildup. 7. Replace the cap on the cartridge. Cure Instructions Allow to dry at room temperature for 24 hours, or after letting sit for 5–10 minutes, cure the gap filler in an oven at 30 minutes @ 70 ˚C. Store between -10 and 40 ˚C in a dry area, away from sunlight (see SDS).