We specialize in hard to find items
All Categories
10HP 30A 220V, Single to 3 Phase Converter, MY-PS-10 Must Be Only Used on 7.5HP(5.5kW) 23A 200-240V 3 Phase Motor, One DPS Must Be Used on One Motor Only, UL Listed
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
10HP 30A 220V, Single to 3 Phase Features
-
DPS can run 3-phase motor with single-phase
-
Very easy to connect DPS and motor
-
Small size & light weight
-
Doesn’t make any high frequency/Lower power consumption
-
Keeps out dust, moisture, and heat due to the sealed type
-
Digital Type Phase Converter/ Excellent start-up torque
-
Efficiency is excellent versus others phase converters
-
Low failure rate/Designed to be non-flammable
About 10HP 30A 220V, Single To 3 Phase
In order to your convenience for your questions, please refer to the following messengers. ▷ Before ordering our DPS, you should check the ampere of your motor and purchase the suitable our DPS. And please give us the information about your motor purpose to recommend suitable DPS to you. Also, please note the below points carefully. 1. MY-PS-10 model is best for 7.5HP motor.(5.5KW, 23 amps) 2. It should only be used for one motor per one DPS. The use of multiple motors is not allowed in our DPS. 3. The input/output voltage of our DPS is 200v~240v. 4. Our DPS is designed to be suitable for use in motor. 5. The efficiency is around 90~95%. 6. The voltage of motor should be 200v~240v. If the voltage of your motor is 380v or 440v, you should change the wire of motor to 200v~240v purpose to connect with output of our DPS. 7. The thickness of wires should be suitable for amperes. 8. Only single phase motor brake is allowed.(Three phase motor brake is not working at our DPS) 9. You could check three phase on the output of DPS when your motor is running. If your motor is not running, you could not check three phase from output of DPS. 10. If your motor has magnetic starter, or electronic switch, or brake, the operating wires of this device should be connected on “U” and “W” of output of our phase converter. Thus, if your motor is not running well or the motor is reversing, you should turn off the power immediately and you have to switch the wires on output(U, V, W) of our phase converter. Actually, when you connect the wires from output of phase converter to your motor, you could succeed in first time, or second time, or third time. A. Detail information 1. Capacity : Suitable for 7.5HP motor(5.5KW, 23 amps) 2. Frequency : 50/60 Hz 3. Dimension(mm) : 99x183x120(WxHxD) 4. Mounting holes : 5Ø 5. Net Weight : 2.6LB(40oz) 6. Voltage of input and output : 200v ~ 240v
