Belimo LMB24-3-T 3 wire motor (BH Kit 1) Replacement Kit for Honeywell M847D motor **Normally SHIPS SAME DAY**

Pay with

Belimo LMB24-3-T 3 wire motor Features

• Stop replacing those troublesome Honeywell spring return motors! This Honeywell to Belimo retrofit kit allows you to easily replace the Honeywell M847D motors with the powerful commerical grade Belimo 3 wire motor, complete with the custom adapters and hardware for your damper.

• 5 year factory warranty - satisfaction guaranteed or your money back!

• Works with round or rectangular dampers - any damper with a 3/8" or smaller drive shaft

• Works with any zone control panel, Honeywell and others, with a 3 wire damper output

• Also works on many zone panels with a 2 wire damper output since the Belimo LMB motor will accept an alternative wiring procedure that places full time 24vac power on terminals 1 and 2, and then uses the current zone board output for terminal 3. Full, illustrated instructions are included.

About Belimo LMB24-3-T 3 Wire Motor

Stop replacing those troublesome spring return motors! This Belimo to Honeywell retrofit kit allows you to easily replace the Honeywell M847D, M847D1004, and M847D1012 motors with the powerful commercial grade Belimo LMB 24-3-T 3 wire motor, complete with the custom adapters and hardware to install on your damper. Belimo is the largest and most respected commercial damper actuator and damper motor maker in the world. Now you can escape the problems of two wire spring return dampers! Many owners don't realize that all "two wire" spring return dampers must pull power continuously to overcome the spring that is trying to pull the damper back to the non-energized position. The result? A motor that wastes energy, gets so hot you cannot touch it, and often fails pre-maturely. Works as a replacement for Honeywell M847D series motors on popular ZD and ARD dampers, including M847D1004 and M847D1012 motors, and other M847D series motors. Also works as a replacement for Trol a Temp MSR, RDMH, and other dampers. This retrofit kit works on many 24vac round or rectangular dampers from Honeywell, Trol a Temp, AprilAire, ZoneFirst, EWC, Robert Shaw, Research Products, Ztech, Buetler, DuroZone, and others with a 3/8" or smaller drive shaft (other kits available for other size drive shafts). 5 year warranty - satisfaction guaranteed or your money back! Works with any panel, Honeywell and others with a 3 wire damper output. Also works on many zone panels with a 2 wire damper output. See our complete line of retrofit damper motor kits and zone control products at Retrozone.com, or call us at 972-633-8104.