Graco Stroller Tire Tube Replacement [Rear Wheels] 16 inch x 1.75 x 2.125 Inner Tubes for Graco Jogging Strollers

Pay with

About Graco Stroller Tire Tube Replacement [Rear

Made to fit all Graco jogging strollers, including the following models: Modes Jogger 2.0 Stroller Modes Jogger SE Stroller Modes Jogger Stroller Trax Jogger FitFold Jogger Stroller FastAction Fold Jogger FastAction Jogger LX Stroller Relay Jogger NOTE:  The only Graco jogger not compatible is the TrailRider Jogger.  Get back on the jogging path as quickly and easily as possible with our replacement tubes for Graco jogging strollers. Replacing your tube shouldn't take more than five minutes. You'll need a couple things: screwdriver (flat-head) and tire pump. Follow the directions below to replace your rear stroller tire tube. You'll also find these on your box packaging! Size: make sure tube size [16 inch x 1.75 to 2.125] matches tire size (found on tire wall). Remove Wheel: carefully remove the wheel completely from the stroller. This may require a flat screwdriver or two to pry off tire wall. Out with the Old: unscrew the old tube valve and remove tube entirely from tire. Pokey Check: run your fingers through tire interior to make sure no sharp objects remain. Line Tire Edge: place one edge of the tire over the tire rim; leave other half hanging off. Mini Inflate: slightly inflate the tube with a few pumps so that it takes shape. In with the New: match up the tube valve with the valve hole and line the new tube within the tire. Line Other Tire Edge: fit the other edge of the tire completely inside the tire wall. Just Add Air: inflate to the recommended pressure shown on your stroller tire then add valve cap. Replace Tire: add tire first… then baby :-) Feel free to reach out with any questions or troubles when replacing your Graco tire tubes. We want to help!