We specialize in hard to find items
All Categories
Bartolini HR-3.4/918 Preamp Harness - 3-Band EQ w/ 3 Control Knobs - Active Only - Pre-wired for a Two-Pickup a Installation
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
Bartolini HR-3.4/918 Preamp Harness - 3-Band EQ Features
-
3-Band EQ w/ 3 Control Knobs
-
Active Only
-
Can be wired for 9 or 18 volt configuration
-
Prewired for easy installation
-
Fits most basses & guitars with 3 holes for control knobs
About Bartolini HR-3.4/918 Preamp Harness - 3-Band EQ
Give your guitar or bass a new voice with a custom Bartolini on-board preamp. These harnesses are prewired for easy installation and offer a variety of configurations to meet your needs. Bartolini is one of the most respected & trusted pickups & electronics builders in the industry and offers some of the finest electronics using only the highest-grade materials. Every Bartolini preamp & pickup is hand-built right here in the USA. All preamps feature a Gain trim pot on the module for fine-tuning, and all tone & blend pots feature smooth action & center indents with 6mm knurled split shafts. Controls knobs with set screws are recommended, but not included. Controls are: - Volume/Volume Concentric (Stacked) - Bass/Treble Concentric (Stacked) Boost/Cut - Mid Boost/Cut with Push/Pull for frequency selection (switch between hi-mid & low-mid) What's in the box: (1) Pre-wired Preamp Harness (1) Extra Battery Connector for 18 Volt installations (requires soldering if used) (2) Sets of Black plastic knobs for concentric pots (1) Wiring Diagram PLEASE NOTE: Preamps that have been installed or attempted to be installed are not returnable unless defective. Check to make sure you have the correct preamp & check the fitment before attempting to install it.
