RA AquaTech Aquarium Glue Clear for Plants Corals aquascaping Instant Aquarium Safe (4pcs Pack)

Pay with

RA AquaTech Aquarium Glue Clear for Plants Corals Features

• Note: For aquarium live plants, corals, small artificial decoration or small rocks. If you need to glue large decoration or rock, use silicone instead.

• Note: Unlike some adhesives that cure by evaporation or heat, this cyanoacrylate is aquarium-safe stable formula that needs moisture to cure. If applied in a dry environment, spray some water to expedite the curing process. If an excess amount of glue is exposed to air without sufficient moisture, it will not cure properly.

• For the best result, always apply the glue directly to the point of contact between surfaces not "around" it. Depends on the moisture level and the amount of glue used, the fixture time varies from 10second to 30mins, full cure time varies from 10mins to 24 hours. You don't have to wait! Once it cured to partial strength, place it in your aquarium and let it fully cure underwater.

• Superior cyanoacrylate gel, extremely thick formula. Works underwater or above water. Insoluble in water, 100% safe for freshwater, saltwater aquariums & reptile (heat resistant up to 150F)

• 5grams each tube, total 20grams per pack. Small individual package, increase utilization rate.

About RA AquaTech Aquarium Glue Clear For Plants Corals

5 grams each aluminum tube cyanoacrylate gel. DIRECTIONS: Dispense a small amount of glue prior to each use. Apply a small amount of glue to the bottom of moss, plant or coral and press against desired surface for 20 seconds. For bunch plants, apply glue and plant as usual. Wipe tip free of glue before replacing the cap. WARNING: Cyanoacrylate. WARNING: Danger. Keep out of the reach of children. Eye and skin irritant. Wear gloves and proper eye protection. If eye contact occurs, rinse with water for 5-10 minutes and seek for immediate medical attention.