X

12V Remote Control Switch for Motor, 433Mhz RF Wireless Remote Switch Motor Controller Power Saving 6MA, Motor Forwards Reverse Stop DC3V 3.7V 4.2V 4.5V 5V 6V 7.4V 9V 12V

Product ID : 34531735


Galleon Product ID 34531735
Model
Manufacturer
Shipping Dimension Unknown Dimensions
I think this is wrong?
-
1,639

*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown

Pay with

About 12V Remote Control Switch For Motor, 433Mhz RF

Description*The world's smallest micro-motor forward and reverse Remote controller,it input DC3V-12V output DC3V-12V,to control the output positive(VCC+) and negative(GND-) exchange, voltage from DC3V to 12V is ok *MOS non-contact(Contactless) (No Noise )silent receiver, ultra-low power standby current is only 0.5mA, it is suitable for battery-powered motor,especially the door mini motor which with a small battery-powered.Working voltage: DC3V-12V ( battery please more than DC3.7V)(Wide working voltage DC3V-12V , 3.3V--12V All is ok)Working current: 6ma Standby current: 0.5ma Operating frequency: 433.92MHZSize: 21*11*5mm*(Ultra low standby current, it is suitable for battery-powered, when it is standby will automatically enter the low-power sleep state, please press the remote control button hold for 0.5 seconds or more)*Maximum load: 0.4A (400ma mA) have better load less than 0.2A (200ma mA)The receiver itself with overcurrent protection, when the current exceeds the rated current,will be entered into turn off power protection,such as the motor to start or block the current is doubled,beyond the rated current will be flashWorking Mode*1.Momentary--Press the button "Up arrow",the Motor Forward,Release is Stop;Press the button"Down arrow", the Motor Reverse,Release is Stop.*2.Latched--Press the button"Up arrow"the Motor Forward,Press "Square button " is Stop;Press the button"Down arrow", the Motor Reverse,Press "Square button " is StopNotice: we send latched mode defaultchange to momentary: Connect the Learning Button(Used tweezers) Until the receiver Led indicator flash for 2 times, it mean Change M4 successfully. 1:Input 12V for the Receiver,Connect the Learning Button,don't release 2:the Led indicator will flash for 1 times,don't release . 3:the Led indicator will flash for 2 times then release,the working mode will change MomentaryPackage Include: 1 x Receiver 1 x Transmitter