We specialize in hard to find items
All Categories
KINGPRINT TMC2208 Stepper Motor Mute with Heat Sinks Driver Stepstick Mute Replacement A4988 Drv8825 for 3D Printer(Pack of 4 PCS)
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
About KINGPRINT TMC2208 Stepper Motor Mute With Heat
Specification: Configuration:CFG or UART Microsteps: Up to 1/256 MicroPlyer: 1/256 Logic Voltage VI0: 3-5V Motor Voltage : 5.5-36V Motor Phase Current: 1.2A RMS, 2.0A Peak How to use: 1. Pay attention to the direction, specific reference to guide the use of instructions; 2. In the printer control board when used, please correspond to the breakdown table, through the socket under the jump line caps to select the subdivision mode; 3. The heat sink directly affixed to the IC, pay attention to the heat sink and pin spacing, or will be made the heatsink is connected with each pin to cause a short circuit. Note: 1.Vref measure the voltage at the middle end of Gnd and potentiometer. 2.The measurement of voltage must not connect the motor, otherwise easy to burn drive. 3.The measurement of voltage should be connected to the power supply, do not only connect USB power supply. 4. Please check the merchandise before use.Do not insert incorrectly.5.long-term work will produce heat, you can do a good job of heat dissipation.6. If you have any questions, please contact us in time. Package Included: 4*TMC2208 4* Heat Sink
