Zapp3D Design Silicone Mold | Christmas Ornament Mold for Resin | Multipurpose DIY Arts & Craft Supplies - Round Ornament Mold for Epoxy Resin, Jesmonite, AquaResin, Concrete, and More!

Pay with

Zapp3D Design Silicone Mold | Christmas Ornament Features

• ✅ ZAPP3D DESIGN Ornament Resin Mold: This resin mold produces an ornament that measures 5 x 4 inches and 3/8 (.375) inches thick. Zapp3D Design Ornament molds feature a solid back which will give you a flat surface without bowing or deformations. The side walls around the mold are .25 inches THICK holding the shape of your resin piece. Zapp3D Design molds are much thicker and stronger than other brands. Their WEIGHT measures approximately 70g.

• ✅ PREMIUM QUALITY MATERIAL These Round Ornament epoxy resin casting molds are made of High-Quality Platinum silicone Shore 15A material. It is sturdy, durable, reusable and super easy to de-mold. These molds will give your resin piece a smooth, glossy interior surface which can last for a long time. You can expect 30 plus uses before the shine degrades and 60 plus uses before a replacement mold is needed. Results may vary pending mold design, care and handling.

• ✅ ZAPP3D DESIGN Silicone Ornament molds are made in the USA!

• ✅ ZAPP3D DESIGN Silicone Ornament molds are compatible with many casting materials such as epoxy resin, concrete, cement, jesmonite, aqua resin, etc. You can add resin pigments, dyes and embellishments.

• ✅ Thick - These Ornament Molds are thicker than most others. They are 3/8 (.375) inch thick! This allows for many inclusions such as dried flowers, glitters or many embellishments and keepsakes.

• ✅ Easy to Hang - Every round silicone ornament mold comes with a large hole designed into the top of the mold. This feature makes it easy to hang and provides a sturdy hole. No drilling necessary!

• ✅ Silicone Mold Care Instructions - Don't Touch the inside shiny part of the mold. This will cause permanent scuffs that will show in your final cast. Use Extreme Caution when using a torch/heat gun to pop bubbles in the resin. It may rip the mold upon de-molding your fully cured resin. Instead try a mist of alcohol over the resin. The molds are heat resistant up to 450 degrees Fahrenheit or 232 degrees Centigrade. They are suitable for casting low temperature melt metal alloys.

About Zapp3D Design Silicone Mold | Christmas Ornament

Round Christmas Ornament Mold for Resin, DIY Ornament Mold, Christmas Resin Molds