We specialize in hard to find items
All Categories
Leader Accessories New Easy Setup Class A RV Cover Motorhome Cover Fits RV with Assist Steel Poles (33'-37')
Share Tweet
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
About Leader Accessories New Easy Setup Class A RV Cover
This RV cover is designed for a new installing method. It can save lots of your time. 1.Adjustable front & rear tension panels provide a custom-like fit2.Multiple zippered panels for easy access to the front, back & sides3.Reflective panels for safe parking at night4.Air vents reduce wind lofting and inside moisture5.Reinforced corner patches resist tears and snags6.Elasticized bottom corners for fast and easy fitting7.Unique Rope tie down aid 8.Full cut to allow room for ladders,air conditioners etc.9.Easy installation,easy removal10.Free Storage bag and ladder cap included11. With a pair of assist steel pole to lift and pull your cover?/p>New Installing Method1. Unpack the cover, spread it on ground, unzip the zippers of BACK panel of RV cover, roll up BACK panel completely and secure it on top panel with sew-in velcro tapes.(Tip: Spread the entire cover on clean ground, find out the front panel or back panel first, DO NOT OPERATE ON DIRT GROUND!)2. There are 2 pockets on each side panel top near the end of the cover. 2 person point the steel poles into each pocket and lift it up at the same time3. Both of operators stand by the end of RV, raise the cover up over the roof of RV, pull the cover carefully from the end to the front of RV until the cover is on the correct position. (Tip: If you feel hard to moving forward, check if the cover is stuck by any corners or sharp edges of RV roof. If it was stuck, operators can move to pockets on the middle of cover, and pull again.) 4, Release the front panel from velcro, zip all zippers, put all buckles & straps on, and done.
