Homyl 13V~18V Satellite Finder With Analog Meter For Direc TV SF02 Easily Calibrate The Optimum Signal,Black Silver with 2 Lights

Pay with

About Homyl 13V~18V Satellite Finder With Analog Meter

Description: - Connect a jumper cable from the LNB/LNBF to the "TO LNB" connection on the Satellite Finder,Connect the cable from your satellite receiver to the "TO REC" input on the Satellite Finder. - Make sure your satellite receiver is on . The Satellite Finder's scale should be lighted at this time and the meter reading should be around 2. - Set your dish to the proper azimuth and elevation settings, (This information should be supplied with your dish)Set the Satellite Finder's scale reading to about 5 by adjusting the level control found on the face of the Satellite Finder(Turning the knob clockwise will increase the reading). - Peak the signal by slowly moving the azimuth and elevation of your dish. If the Satellite Finder's reading becomes full scale, adjust the level control knob to reduce the reading to around 5(Turning the knob counterclockwise will decrease the reading) . - Continueto move the dish until you have the highest possible meter reading.Specification: - Material: Plastic - Size: 120mm - 0.2 dB difference in 950 - 2150MHz range - 13-18v DC - LNB to REC connectors with a dB level controlPackage Includes:1 Piece Satellite Finder1 Piece User's GuideNote:When connecting to a LNBF with gain higher than 65dB, insert a 5dB attenuator between the meter and the LNBF.If a attenuator is not available you may use a long coax (60 feet or more) between the meter and the LNBF. If the meter needle is jumping the sensitivity is too high. Be very careful not to damage the adjustment by turning it too far or too hard. Choose all you need in our store. You will have a nice purchase experience and get quality products and service corresponding to the policy of Amazon.