beler 100pcs 9mm Anti-Slip Screw in Tire Snow Spikes Racing Track Car Wheel Ice Studs

Pay with

About Beler 100pcs 9mm Anti-Slip Screw In Tire Snow

SpecificationsCondition: 100% newColor:SilverMaterial: Carbide AlloyBody Length: approx.8mm(0.31inch)Overall Length: approx.9mm(0.35inch)Base Diameter: approx.4mm(0.16inch)Pin Diameter: approx.2.3mm(0.09inch)Item included: 100 x Tire Non-slip ScrewsSuitable for: car racing,car road,motorcycle,bike,boot and all kinds of tiresNote:1) All dimensions are measured by hand, there may be small deviations.2) Color may vary slightly due to the color setting of each individual monitor.3) Please confirm the bolt size according to the thread depth of the tire before purchasing.4) Using a smaller stud than stated can result in an ineffective stud, and one that's too long can cause the stud to dislodge from the tire.Feature:1) It can be easily installed and removed.2) When not in use, it could be removed lightly and stored for using again in the following season.3) Add ultimate off-road capability to your normal ATV, UTV or 4X4.4) Low ground pressure.Environmentally with minminum impact.How to install the tyre studs:A stud gun,a pneumatic device that resembles a hand gun,is used to insert the stud into the hole in the tread of the snow tire.1) Drill (using a very small bit) down from the center of chosen knob into the tire.2) Drill a screw up from inside-out. If the angle is not perpendicular to the tire,it will stick out one side or the other.Do one hole and screw at a time. Don't try drilling all the holes, then installing screw.3) Put duct tape over the screws on the inside of the tire; sometimes it is best to use two layers of tape.