Apollo 76-500 Series Stainless Steel Ball Valve, Two Piece, Inline, Spring Return Lever, NPT Female

Pay with

Apollo 76-500 Series Stainless Steel Ball Features

• Made of stainless steel for resistance to corrosion

• Stainless steel spring-return lever handle to ensure the valve is open only when an operator is at hand

• Pounds per square inch (gauge) (psig) rating of 2,000 for water, oil, and gas (WOG) for 1/4” to 1” valves; 1,500 for 1-1/4” to 2”; and 150 for saturated steam

• Female National Pipe Taper (NPT) threads on both ends for connecting to male threaded pipes

• Multifill polytetrafluoroethylene (MPTFE) seats and stem packing reduce the risk of valve leakage

About Apollo 76-500 Series Stainless Steel Ball

The Apollo 76-500 series two-piece inline ball valve is made of stainless steel and has a spring-return lever handle and female National Pipe Taper (NPT) threaded connections on both ends. This valve is made of stainless steel for resistance to corrosion and has a stainless steel spring-return handle with a vinyl sleeve for manual on/off control. This valve closes automatically when its spring-return lever is released, ensuring that the valve is open only when an operator is at hand. The maximum pressure is 2,000 pounds per square inch (gauge) (psig) for water, oil, and gas (WOG) for 1/4” to 1” valves, 1,500 psig for 1-1/4” to 2” valves, and 150 psig for all sizes for saturated steam. The valve is inline for connecting two pipes going in the same direction and has NPT threads on both ends for creating tighter seals than straight threads. Multifill polytetrafluoroethylene (MPTFE) reinforced seats and stem packing reduce the risk of valve leakage and this ball valve is standard (or reduced or regular) port for reduced valve size and cost. This valve is for use with water lines, processing plants, and agricultural applications and meets standard MSS SP-110 for quality assurance. Ball valves use a spherical disc to control the flow between pipes, tubes, or hoses. Flow is allowed when the hole that pierces the ball-shaped disc is in line with the inlet and outlet of the valve. Flow is blocked when the ball is horizontally swiveled 90 degrees, so that the hole of the ball is perpendicular to the opening of the valve. Ball valves can be referred to as full port or reduced port (also known as regular or standard port) depending on the inner diameter of the valve. A ball valve is full port if the hole of the ball is the same size as the inner diameter of the connecting pipeline (resulting in lower friction) and is reduced port if the hole of the valve is one pipe size smaller than the pipe, resulting in less flow through the valve than through t