Narex Unhandled Dual Bevel Marking Knife Kit with Finger Indents Stainless Steel Blade (0.100" Thick Blade)

Pay with

Narex Unhandled Dual Bevel Marking Knife Kit with Features

• A marking knife is an invaluable tool that should be in the toolbox of every woodworker. A good marking knife can produce crisp and well-defined marks on wood essential when laying out precision joinery or transferring measurements. Scribe lines left by a marking knife can also locate and guide chisels and saws. This Dual Bevel Spear Point marking knife is made by Narex, a world-class edge tool manufacturer in the Czech Republic.

• The blade is made from AISI 420 corrosion resistant stainless steel and hardened and tempered to HRC 57. This steel is a traditional knife steel and designed to take and hold a keen edge and resist corrosion. The blade is 5-7/8 inches long, 1/2 inch wide and come in 3 thicknesses: 0.030", 0.060" or 0.100 inch thick.

• The blade has a dual-bevel spear point tip. The tip is ground to 55 degrees with a 25-degree grind on both bevels. The bevels are precision ground on CNC machines. The laser cut finger indents are useful for applying pressure closer to the tip.

• The dual bevel will mark distinct lines on both the right and left side of a part or guide. It will leave crisp lines when marking with and against the grain and on end grain. The knife may require just a light stropping to remove a small wire edge to get it razor sharp and ready to use.

• The knife can be used either unhandled or wood scales can be attached to create a handle. If a handle is desired the kit comes with 2 brass pins to affix scales to the blade.

About Narex Unhandled Dual Bevel Marking Knife Kit With

A marking knife is an invaluable tool that should be in the toolbox of every woodworker. A good marking knife can produce crisp and well-defined marks on wood essential when laying out precision joinery or transferring measurements. Scribe lines left by a marking knife can also locate and guide chisels and saws. This Dual Bevel Spear Point marking knife is made by Narex, a world-class edge tool manufacturer in the Czech Republic. The blade is made from AISI 420 corrosion resistant stainless steel and hardened and tempered to HRC 57. This steel is a traditional knife steel and designed to take and hold a keen edge and resist corrosion. The blade is 5-7/8 inches long, 1/2 inch wide and come in 3 thicknesses: 0.030", 0.060" or 0.100 inch thick. The blade has a dual-bevel spear point tip. The tip is ground to 55 degrees with a 25-degree grind on both bevels. The bevels are precision ground on CNC machines. The laser cut finger indents are useful for applying pressure closer to the tip. The dual bevel will mark distinct lines on both the right and left side of a part or guide. It will leave crisp lines when marking with and against the grain and on end grain. The knife may require just a light stropping to remove a small wire edge to get it razor sharp and ready to use. The knife can be used either unhandled or wood scales can be attached to create a handle. If a handle is desired the kit comes with 2 brass pins to affix scales to the blade. Knife specs: Blade material: AISI 420 corrosion resistant stainless steel hardened HRC 57 Blade profile: standard thickness with finger indents Blade length 5-7/8” Blade thickness: 0.030", 0.060" and 0.100” Blade width: 1/2”