62-23543-01 Furnace Burner Flame Sensor Rod(OEM) for Rheem - By TOMOON（3 pack）

Pay with

About 62-23543-01 Furnace Burner Flame Sensor

PART INFORMATION This burner flame sensor (part number 62-23543-01) is for furnaces.(3PACK) Replace Part NO:62-23543-01,62-23543-02, 62-23543-03, 62-23543-04 FITS Model NO：RGDG, SGDG, RGDJ, RGFD, RGLG, RGLH, RGLJ, RGLK, RGLL, RGLN, RGLQ, RGLR, RGPH, RGPJ, RGPK, RGPL, RGPN, RGPP, RGPQ, RGPR, RGRA, RGRB, RGRJ, RGRK, RGRL, RGRM, RGSA, RGTA, RGTJ, RGVG, RGVH, RGVJ, 80LJ, 80LS, 80PJ, 80PS, 90RJ, 90RS, 90RT, 90TJ, 90TS, RGFE, RGFG, RGLE, RGLS, RGLT, RGPE, RGPS, RGPT, RGRS, RGRT, RGTS, SGPG, SGPN SPECIFICATION ►Length (Mounting Flange to Sensor Tip): 2-1/2" ►Length-Sensor Offset: 1-9/161 ►Angle - Sensor Offset (degrees): 90. ►Termination: 1/4" Male Quick Connect INSTALLATION STEPS ►Shut off the power to your furnace (or any other appliance), prior to making any repairs. There will usually be a light switch (toggle switch)on or near your furnace. If this switch is not present, furnaces have a dedicated breaker; locate your furnace breaker and shut your unit down. ► Remove the Sensor. Find the broken sensor. The sensor is easily accessible and typically mounted by one 1/4” hex head screw. Upon removing this screw, the sensor will slide out so that you can easily clean it. Carefully remove the sensor; ► Remove one sensor and replace it with our new sensor. ► Simply reconnect the wire if you’ve taken it off, remount the sensor to the burner assembly using the 1/4” screw, replace the door(s) on the unit, and turn the power back on. ► Check Your Results. If the unit takes a few extra seconds to start up or the fan immediately kicks on and runs for a bit, this is normal. Shutting down the power to the unitcan cause it to reset and run through a short series of checks before trying ⚠️Installing this part. Wear work gloves to protect your hands.