We specialize in hard to find items
All Categories
*Price and Stocks may change without prior notice
*Packaging of actual item may differ from photo shown
- Electrical items MAY be 110 volts.
- 7 Day Return Policy
- All products are genuine and original
- Cash On Delivery/Cash Upon Pickup Available
CONFAST 1/2" x 4-1/4" Galvanized Wedge Anchor Features
-
GALVANIZED - Helps prevent rusting in moist environments
-
WIDE RANGE OF SIZES - Insures proper fastener for best results
-
PACKAGED WITH NUTS AND WASHERS - Fast, quick, complete installation
-
HOLE SIZE IS ANCHOR SIZE - Simplicity and ease of installation
About CONFAST 1/2" X 4-1/4" Galvanized Wedge Anchor
Applications The anchor is made from Carbon Steel, and is Galvanized Carbon-Steel. This anchor is designed for use in Concrete only, and should never be used in block or brick base material. Environment The anchor is designed for use in a Damp environment. Hole Diameter/Bit Diameter The anchor requires a 1/2" hole to be drilled in the base material (Concrete only). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill. Diameter of Anchor The diameter of the anchor is 1/2". Length Anchor The length of the anchor is 4-1/4" Thread Length The length of the threads on the anchor is 2-3/4" in length. Minimum Embedment The minimum anchor embedment into the concrete is 2-1/4". Therefore, the anchor must be installed so that a minimum of 2-1/4" of the anchor is embedded into the concrete. Maximum Fixture Thickness The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 1-1/2". This will ensure that the minimum embedment of 2-1/4" will be met. Fixture Hole Diameter The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 1/2" diameter anchor requires the hole in the fixture to be 5/8". Torque Value To be set properly in the concrete, the anchor must be torqued to between 50 - 60 ft./lbs. Spacing between Anchors Each anchor must be spaced a minimum distance of 5" from each other when measured center to center. Edge Distance It is very important not to install the anchor any closer than 2-1/2" from an unsupported edge of the concrete.
